description Installation Instructions keyboard_arrow_down
- None Available
unarchive In The Box of 191725 keyboard_arrow_down
- 2 of Tie Rod Boots - 60520
lock Warranty Information keyboard_arrow_down
- Lifetime Warranty. Prothane guarantees all Prothane Suspension Parts to be free of defects in materials and workmanship (not due to abuse, neglect or misapplication) for the total time the vehicle remains with the original purchaser of the product(s). Should the products fail to meet these conditions, Prothane will replace the product, free of charge. This excludes any and all related labor charges. The product must be shipped to Prothane (postage prepaid) along with a copy of the original receipt."
Prothane Polyurethane Universal Dust Boots
Many of you are finding out that the rubber boot on your ball joint or tie rod has rotted away or has split. These boots are extremely important for the suspension of your vehicle. Fortunately, Prothane makes Universal Dust boots that will fit most vehicles. These dust boots are made of polyurethane and are far more durable than rubber. This will seal your boot to retain the grease in the joint, as well as protecting the joint from dirt, sand, water, and snow.
How-to obtain measurements
In order to select the proper boot, you will first need to grab a few measurements. The best way to do this is with a set of digital calipers. You will need to measure the diameter of the base where the boot will sit, the diameter of the shaft (also called the Pin Opening Diameter) and the height of the boot. Once you have gotten to your tie rod end measure these three spots. Be sure to be as exact as possible and to write down your measurements. If you have any trouble getting these measurements, give our customer service team at DST a call. It is important to note that you do not want to choose a boot that is bigger than your measurements. You want to choose a boot that is just slightly smaller than the measurements you obtained. The elasticity of the polyurethane will allow the hole to stretch and grip the joint tightly. If you choose a boot that is too large there will be a gap which lets in debris.
After Measureing Your Dust Boots
Now that you have these measurements, you can verify that this is the boot that you need. If you find that your measurements do not match this boot, go to our Universal Dust Boot page to match a part to your measurements.
Product Reviews for Outer Tie Rod Dust Boots - Ford Mustang - 191725
- 5 Star (1)
-
-
- 50%
-
- 4 Star (1)
-
-
- 50%
-
- 3 Star (0)
-
-
- 0%
-
- 2 Star (0)
-
-
- 0%
-
- 1 Star (0)
-
-
- 0%
-
Prothane 191725
starstarstarstarstar_border" I purchased these over the web and site was friendly and easy to use. The after sales service was great and the parts arrived promptly. "
The boots were a "best fit" and of good material and quality. I would suggest that they could have had an internal retainer lip which would suit my purpose of replacing the original boots.
verified_user Verified Buyer - Brian Eyre - . Prothane 191725 - 4 out of 5starstarstarstarstar" Outstanding "
My street rod was built 30 years ago and after I purchased it, (its a survivor) I noticed that the dust boots were basically GONE! I looked around locally but the parts houses here didnt have much of anything, then I ran across this ad. I measured the tie rods ends and called. They were outstanding in quality, fit and finish. Installed quite easily and am very--very happy with the product.They were shipped and recieved them in the mail. They came quickly. Overall, Id order them again if needed.
verified_user Verified Buyer - Jonathan Delpozo - . Prothane 191725 - 5 out of 5